|
A.
Condition of Base:
- Surfaces
must be clean, dry, structurally sound and free of efflorescence,
grease, oil, form release agents and curing compounds.
- For
additional options for surface preparation, contact LaHabra
Technical Services Department.
B.
Mixing:
- Mix
thoroughly. Up to 2 gallons (7.5L) of clean potable water
can be added.
- Avoid
creating air bubbles or foam.
C.
Application:
- Apply
with a roller, brush or suitable spray equipment in a continuous
coat.
- LaHabra
Acrylic Primer must completely dry before any LaHabra finish
coating is applied.
D.
Drying Time: The drying time of LaHabra Acrylic Primer
is dependent upon the air temperature and relative humidity.
Under average conditions (70°F, 55% R.H.), LaHabra Acrylic
Primer is dry to the touch in 1/2 hour and sufficiently dry
for application of finish in 2 hours. Protect from rain for
at least 4 hours.
E.
Cleanup: Water soluble prior to drying. Clean tools and
containers with water prior to drying.
Cautions
and Limitations
A. Ambient
and surface temperatures must be 40°F (4°C) or above
during application and drying time. Supplemental heat and
protection from precipitation must be provided as needed.
B. Use
only on surfaces that are sound, clean, dry, and free from
any residue which may affect the ability of the LaHabra Acrylic
Primer to bond to the surface.
G. See
package for handling precautions.
H. Always
wear proper safety equipment, including particle mask, when
mixing and/or applying this product.
Information
contained herein conforms to general recommendations for the
installation of LaHabra Acrylic finish, and is provided in
good faith. LaHabra Products, Inc. assumes no liability, expressed
or implied, as to the workmanship, engineering or architecture
of any project.
|
How To Apply
