DESCRIPTION
A 100% acrylic emulsion additive for portland cement-based products.

USES
Admix100 is to be added to Aged Limestone and Plaster Mix to increase their mechanical strength, heat and UV light resistance, chemical resistance properties, adhesion and cohesion properties, curing characteristics and workability.

ADVANTAGES
’ Improves adhesion
’ Increases workability
’ Aids in the development of strength
’ Reduces the likelihood of shrinkage cracking

PACKAGING
1 quart bottles and 5 gallon pails

COVERAGE
Varies by chosen mix ratio and the product that Admix100 is being used to enhance.

COLOR
Milky white

SURFACE PREPARATION
In all cases, substrate surface must be clean and sound. All loose and disintegrated materials, traces of oil, grease, dirt, dust, efflorescence, mold, mildew, release and curing agents must be removed.

MIXING
Admix100 is an acrylic polymer. Mix Admix100 and water prior to adding to dry material.

• The normal ratio with potable water is 1 part Admix100 to 3 parts water (1:3). See appropriate data sheet for Admix100 to water ratios on Aged Limestone.
• If enhanced performance is desired, increase the amount of Admix100 to 1:2 or 1:1 Admix100 to water ratio.
• Always use a mechanical stirrer when mixing the material.

APPLICATION
LaHabra requires that all applicators attend an educational seminar on LaHabra Specialty Finishes. LaHabra recommends that the project owner or designer approve a job site mock-up of the application of this product. The mock-up should demonstrate the products' appearance under the conditions given by the project specification(s).

• When blended, the product should be applied immediately.
• Latex-modified cement products form "skin" rapidly, particularly in warm weather. The skinning reduces the workability, and pot life, therefore the material is good for only 20 to 30 minutes.
• Dispose of mixes which have begun to skin or set. Skinning indicates loss of ultimate strength and performance.
• Use liquid mixes to wet tools for finishing.
• Do not overwork surfaces, as the finish will tend to “tear” as it skins.

CLEAN UP
Clean tools frequently using clean water as build-up of cured latex-modified cement products are very difficult to remove.

MAINTENANCE
Refer to the literature of the product that you are using Admix100 to enhance for appropriate maintenance procedures for that product.

STORAGE AND HANDLING
Keep container closed after each use. Protect from freezing. Wash thoroughly after handling. Avoid eye and skin contact. In case of contact, flush with clean water and seek medical attention if irritation persists.

SHELF LIFE
If the product remains in an uponened, undamaged, orignal sealed pail that is properly stored, Admix100 has a shelf life of 1 year.

LIMITATIONS

• Do not use Admix100 when the temperature is below 40 °F (4 °C). High relative humidity and low temperatures will retard the curing process of the mixes.
• Do not use Admix100 as a bonding agent or as a primer.
• Do not use with air entrained cement.
• Use with proper ventilation.

TECHNICAL DATA
Test Results (28 day air cure)

	Unmodified Cement	With Admix100
Tensile Strength	235 psi	615 psi
Compressive Strength	2390 psi	5795 psi
Flexural Strength	610 psi	1585 psi
Impact Strength	6 psi	16 psi

Technical and Field Services available upon request.

This information is designed to guide you and has been conscientiously compiled according to the latest state of our technology. No liability can be accepted in connection with the use of the product because of the great variety of applications and working conditions.